NETGEAR ProSafe SRX5308 Reference Manual page 77

3. Enter the settings as explained in the following table:
Table 15. Add Static Route screen settings
Setting
Route Name
Active
Private
Destination IP Address The destination IP address of the host or network to which the route leads.
Subnet Mask
Interface
Gateway IP Address
Metric
4. Click Apply to save your settings. The new static route is added to the Static Routes table.

To edit a static route that is in the Static Routes table:
1. On the Routing screen (see
column for the route that you want to modify. The Edit Static Route screen displays. This
screen is identical to the Add Static Route screen (see the previous screen).
2. Modify the settings as explained in the previous table.
3. Click Apply to save your settings.

To delete one or more routes:
1. On the Routing screen (see
the route that you want to delete, or click the Select All table button to select all routes.
2. Click the Delete table button.
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Description
The route name for the static route (for purposes of identification and
management).
To make the static route effective, select the Active check box.
Note: A route can be added to the table and made inactive, if not needed. This
allows routes to be used as needed without deleting and re-adding the entry. an
inactive route is not advertised if RIP is enabled.
If you want to limit access to the LAN only, select the Private check box. Doing so
prevents the static route from being advertised in RIP.
The IP subnet mask of the host or network to which the route leads. If the
destination is a single host, enter 255.255.255.255.
From the drop-down list, select the interface that is the physical network interface
(WAN1, WAN2, WAN3, WAN4, or DMZ) or virtual interface (VLAN profile) through
which the route is accessible.
The gateway IP address through which the destination host or network can be
reached.
The priority of the route. Select a value between 2 and 15. If multiple routes to the
same destination exist, the route with the lowest metric is used.
Figure 39
Figure 39
LAN Configuration
on page 76), click the Edit button in the Action
on page 76), select the check box to the left of
77