NETGEAR ProSafe SRX5308 Reference Manual page 186

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
4. Specify the settings that are explained in the following table.
Table 45. VPN client authentication settings (Mode Config)
Setting Description
Interface Select Any from the drop-down list.
Remote Gateway Enter the remote IP address or DNS name of the VPN firewall. For example, enter
10.34.116.22.
Preshared Key Select the Preshared Key radio button. Enter the pre-shared key that you already
specified on the VPN firewall. For example, enter H8!spsf3#JYK2!. Confirm the key in
the Confirm field.
IKE Encryption
Authentication
Key Group
5. Click Apply to use the new settings immediately, and click Save to keep the settings for
future use.
6. Click the Advanced tab in the Authentication pane. The Advanced pane displays.
Figure 115.
Virtual Private Networking Using IPSec Connections
Select the 3DES encryption algorithm from the drop-down list.
Select the SHA1 authentication algorithm from the drop-down list.
Select the DH2 (1024) key group from the drop-down list.
Note: On the VPN firewall, this key group is referred to as
Diffie-Hellman Group 2 (1024 bit).
186