NETGEAR ProSafe SRX5308 Reference Manual page 150

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Note: This is the name for the authentication phase that is used only for the
VPN client, not during IKE negotiation. You can view and change this name in
the tree list pane. This name needs to be a unique name.
The Authentication pane displays in the
Authentication tab selected by default.
Figure 92.
4. Specify the settings that are explained in the following table.
Table 33. VPN client authentication settings
Setting Description
Interface Select Any from the drop-down list.
Remote Gateway Enter the remote IP address or DNS name of the VPN firewall. For example, enter
10.34.116.22.
Preshared Key Select the Preshared Key radio button. Enter the pre-shared key that you already
specified on the VPN firewall. For example, enter I7!KL39dFG_8. Confirm the key in
the Confirm field.
IKE Encryption
Authentication
Key Group
Virtual Private Networking Using IPSec Connections
Configuration Panel screen, with the
Select the 3DES encryption algorithm from the drop-down list.
Select the SHA1 authentication algorithm from the drop-down list.
Select the DH2 (1024) key group from the drop-down list.
Note: On the VPN firewall, this key group is referred to as
Diffie-Hellman Group 2 (1024 bit).
150