FR328S Cable/DSL ProSafe Firewall with Dial Back-Up
These LEDs are green when lit, except for the TEST LED, which is amber.
Table 1-1:
LED Descriptions
Label
POWER
TEST
MODEM
INTERNET
100
LINK/ACT (Activity) On/Blinking
LOCAL
100
LINK/ACT
(Link/Activity)
The Firewall's Rear Panel
The rear panel of the FR328S
Viewed from left to right, the rear panel contains the following elements:
•
DB-9 serial port for modem connection
•
Factory Default Reset push button
•
Eight Local Ethernet RJ-45 ports for connecting the firewall to the local computers
•
Internet WAN Ethernet RJ-45 port for connecting the firewall to a cable or DSL modem
•
AC power adapter input
1-6
Activity
Description
On
Power is supplied to the firewall.
On
The system is initializing.
Off
The system is ready and running.
On/Blinking
The port detected a link with the Internet WAN connection or
Remote Access Server. Blinking indicates data transmission.
On/Blinking
The Internet port is operating at 100 Mbps.
The port detected a link with the Internet WAN connection and is
operating at 10 Mbps. Blinking indicates data transmission.
On/Blinking
The Local port is operating at 100 Mbps.
On/Blinking
The Local port has detected a link with a LAN connection and is
operating at 10 Mbps. Blinking indicates data transmission.
(Figure
1-2) contains the connections identified below.
M O DEM
8
Figure 1-2: FR328S Rear Panel
LO CA L
1 0 / 1 0 0 M
IN TER N ET
7
6
5
4
3
2
1
1 2 V D C O . 5 A
Introduction