Rotate Cutter Assembly; Hedge Trimming - Echo 99944200595 Operator's Manual

99944200595
5. Rotate blades to desired cutting position and hold in place.
6. Turn indexing ring ¼ turn to lock blade in place.
Gear case assembly becomes HOT during use. Always
grip assembly at blade-adjustment handle when making
cutting angle adjustments, otherwise serious injury may
result.
Always install blade cover, and return cutting assembly to folded/locked position for travel/storage.

Rotate Cutter Assembly

Always use the unit from the right-hand side of your body – NEVER from the left side. Rotate cutter
assembly 180 degrees on driveshaft in order to avoid cutting directly above your head, and to avoid contact
with hot muffler.
1. Loosen gearcase clamping screw (A), hand guard clamping
screw (B), and remove gearcase locating screw (C).
2. Rotate cutter assembly 180-degrees on driveshaft until
locating hole in driveshaft is visible through locating hole in
gearcase.
3. Install gearcase locating screw (C), and securely tighten all
hardware.
During operation, the complete unit, especially the drive shaft housing and gearcase may become
too hot to touch. Avoid contact when rotating cutter assembly.

Hedge Trimming

Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a poison gas. Breathing CO can cause
unconsciousness, serious injury, or death. Exhaust can cause serious burns. ALWAYS position
unit so that exhaust is directed away from your face and body.
X7532095606
© 08/2013 ECHO Inc.
OPERATION
B
B
C
C
A
13