Equipment - Echo 99944200595 Operator's Manual

SAFETY
Keep a Solid Stance
• Maintain footing and balance at all times. Do not stand on slippery,
uneven or unstable surfaces. Do not work in odd positions or on
ladders. Do not over reach.
Cutting Angle Adjustments
• Only adjust cutting blade angle with unit flat on the ground, with the
engine stop switch in the "STOP" position. Never adjust cutting
angle with unit standing upright.
Avoid Contact With Gear Box Assembly During Use
• Gear box assembly becomes hot during use. Avoid contact with gear box assembly when using unit or
making cutting angle adjustments.
Avoid Hot Surfaces
• During operation, the drive shaft housing and attachment bearing
housing may become very hot, too hot to touch. Avoid contact
during and immediately after operation.

Equipment

Use this attachment with ECHO approved models only. Serious injury may result from the use of this
attachment combined with a non approved ECHO product.
• Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.
• Never adjust blades when the engine is operating.
• Inspect hand guard for damage. Replace if damaged or missing.
• Check that the blade assembly is firmly attached and in safe operating condition. Dull, loose or damaged blades
should not be used.
Note: ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which have not
been tested and approved by ECHO.
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects
away from all openings.
ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before
◆
removing obstructions, clearing debris, or servicing unit.
DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.
◆
NEVER reach into any opening while the engine is running. Moving parts may not be visible through openings.
◆
8
99944200595
X7532095606
© 08/2013 ECHO Inc.