Electrolux W365H Service Manual page 167

Service
Manual
It should be noted that even if imbalances have occurred continually that
are so large that the comparison is made with limit value 4, and the
imbalance suddenly drops below limit value 1, full extraction speed will be
executed.
The distribution time programmed into the drain module does not count
down during the time imbalance measurement is in progress. The
countdown only starts when an approved imbalance value has been
achieved.
In the event that an approved imbalance value is never achieved, the drain
sequence is interrupted, any subsequent extraction is skipped and the next
washing sequence in the washing programme will be executed.
Note that the imbalance measurement is always carried out if the
distribution rpm has been programmed in a drain module. In other words,
irrespective of whether the drain module is followed by extraction or not. If
a drain module is not followed by an extraction, it is necessary to avoid
programming the drain module with distribution rpm as the imbalance
measurement will then be carried out. This takes time, approximately 40
seconds in the best case scenario, although in the worst case scenario, if
limit value 4 has to be used, it can take several minutes.
438 9145-41/03
03.11
23. Programme unit
23
81