Electrolux W365H Service Manual page 153

Service
Manual
TIME DELAY BEFORE DOOR OPENING
UPPER TEMPERATURE FOR ERROR
LOWER TEMPERATURE FOR ERROR
MAX ADJUST TEMPERATURE
MAXIMUM EXTRACT SPEED
DEFAULT WASH SPEED
DISTRIBUTION SPEED
DEFAULT LOW EXTRACT RPM
DEFAULT MEDIUM EXTRACT RPM
DEFAULT HIGH EXTRACT RPM
START EXTRACT SPEED
DEFAULT WASH ACCELERATION
DISTRIBUTION ACCELERATION
RETARDATION ACCELERATION
EXTRACT ACCELERATION
START EXTRACT ACCELERATION
EXTRACT RETARDATION
1
4
7
START EXTRACT SPEED
DEFAULT WASH ACCELERATION
DISTRIBUTION ACCELERATION
RETARDATION ACCELERATION
EXTRACT ACCELERATION
START EXTRACT ACCELERATION
EXTRACT RETARDATION
MAX SPEED DURING FILLING
MAX LEVEL OFFS FOR AUT. CALIB.
TIME AT DISTRIBUTION SPEED 2
NUMBER OF REDIST LOW 1 UNB.
NUMBER OF REDIST LOW 2 UNB.
NUMBER OF REDIST MEDIUM UNB.
NUMBER OF REDIST HIGH UNB.
NUMBER OF REDIST EXTREME UNB.
DRAIN TIME AT PROGR. START
DRAIN TIME AT PROGR. END
READY
1
4
7
438 9145-41/03
03.11
23. Programme unit
0:30
98°C
-9°C
97°C
1200
48
90
550
700
900
1000
20
9
40
40
50
Use the numeric keys to
2 3
enter the value.
5 6
8 9
If you make a mistake while
entering digits:
0
Press ERASE.
When you have finished:
Press .
1000
20
9
40
40
50
100
Use the numeric keys to
2 3
enter the value.
5 6
8 9
If you make a mistake while
entering digits:
0
Press ERASE.
When you have finished:
Press .
Default value, extraction time
Here you determine the various speeds (low,
medium and high) for extraction. The instructions
for determining the length of extraction times are to
be found earlier in SETTINGS 2.
How an extraction sequence works:
In order to extract some of the water from the
load at lower speeds, the drum does not
accelerate to its highest speed immediately.
Instead it accelerates in several steps. This
means that the drum first accelerates to a low
speed level, remains at that for a certain time,
then accelerates to a higher level, extracts at
that speed for a certain time, and so on until it
reaches its final (maximum) extraction speed. If
you program a low extraction speed, the number
of steps at the beginning of the extraction
sequence may be reduced.
Speed
high
medium
low
Start extract speed (i.e. Initial extraction
speed)
Here you determine the speed of initial extraction.
When you are creating a wash program you can
determine (under "Main data") whether it is to
begin with initial extraction. Initial extraction is used
to spin the load outwards against the drum walls,
which makes it absorb water more readily on first
filling. As a result of this the machine will not
require so much extra filling later.
There are two other functions affecting initial
extraction which can be programmed under
SETTINGS 2:
• START EXTRACT TIME
• START EXTRACT ACCELERATION
23
Time
67