Electrolux W365H Service Manual page 129

Service
Manual
To conclude making changes in variables
under "SETTINGS 1"
SETTINGS 1
FLUSH DELAY TIME
FLUSH ON TIME
BUZZER ON BUTTON
MAX FILLING TIME
MAX HEATING TIME
READY
SELECT
SELECT
SETTINGS 1
VERIFICATION ERROR!
CHECK THE STRAP. PRESS SELECT TO TRY AGAIN.
SELECT
SETTINGS 1
OK LOADED! DO NOT FORGET TO
REMOVE STRAP!
SELECT
SELECT
438 9145-41/03
03.11
23. Programme unit
0:06
0:10
Y
10:00
10:00
Press to highlight
READY.
Insert a suitable strap to
short-circuit terminals
X7:1-2 on the CPU circuit
board.
Press SELECT.
The display illustrated left will
appear if you fail to insert the
strap to short-circuit termi-
nals X7:1-2.
Check that the strap bet-
ween X7:1-2 is intact and in
place.
Press SELECT and try
again.
The variables will now have
been stored in the PCU.
Remove the strap between
terminals X7:1-2 on the
CPU circuit board.
Press SELECT.
To prevent inadvertent changes in variables
If you have changed any variables under "Settings
1", when you have finished keying in the changes,
you need to insert a strap between two terminals on
the CPU circuit board to register the changes in the
CPU.
WARNING!
Use a short circuit jumper when strapping pin
X7:1-2.
Do not use a screwdriver or similar as short circuit-
ing a pin to ground may destroy the CPU card.
23
X7
43