Xdsl - Samsung SVR-3200 User Manual

User Manual
Net Mask specifies a range of IP addresses and enables IP addresses in the range to
communicate. Net Mask should be allocated by a network administrator.
Gateway
Gateway must be specified to enable IP addresses to communicate and should be allocated by
a network administrator.
DNS1
DNS1 must be specified to register the DVR to SWR while DNS Address should be allocated by
a network administrator.
Additional DNS
Additional DNS is used to replace DNS1 when it is unstable or has a problem.
Port
Port is used to register to SWR, connect to Network Manager, or connect to Webviewer.
The default port is 4000. Be careful about the port entry when a PPPoE modem
Internet sharing device are in use.
Bandwidth Limit (Mbps)
This sets the maximum transmission speed of data outputted from the DVR, or the data
transmission capability of the DVR. This may be left blank. Ask your network administrator to
specify it when necessary.

6.8.1 xDSL

If the DVR is connected to xDSL and uses PPPoE, set Type to xDSL and specify a user ID and
password. You must use the user ID and password given when you subscribed to the xDSL
service.
65