Install Or Change Supplies - Brady BBP 85 User Manual

Unpacking and Setting up Printer
Setting up the Printer

Install or Change Supplies

2-4
The media and ribbon supply cartridges use a "smart cell" to define and track the
supply information. The system automatically recognizes the supply information
for the installed media and ribbon.
Note: The printer can be either on or off when changing supplies.
Install Ribbon and Media
This procedure assumes you are at the side of the printer, facing the media and
ribbon rolls.
Note: An illustrations on the inside of the cover shows how to install the tape and
ribbon. The two steps on the left refer to loading the ribbon. The four steps on the
right refer to loading the media (tape).
1. Press yellow cover release button and raise printer cover.
2. Place ribbon roll inserts over yellow drive cones on left, then right sides [2].
3. Snap yellow flag into yellow memory cell [3].
2
3
BBP
®
85 Label Printer User's Manual