Programming (Cont.)
Reset
Whites Setting
TOUR Notes
Master Dimmer
Red, Green, Blue
and White Color
Selection
Color Macros
Strobe
ID Address
Selection
Auto
Dimmer Speed
Block Selection
February 16, 2010
This setting allows the user to reset the COLORado™ 3p Tour fixture to its default
values, including the custom programs.
1) Go to SETTINGS > RESET.
2) When prompted, enter the master access password as shown in Control Panel
Lock.
3) Wait for the reset process to finish.
This setting allows the user to select and edit the temperature of the white colors used
in the Macros channel. It also allows the user to define the maximum RGB values when
RGB to White is active.
1) Go to CALIBRATION.
2) Select a white color (WHITE 1~11) or RGB TO W.
3) Select a color (RED, GREEN, BLUE, or WHITE).
4) Select a color value (0~255).
5) Repeat for the other colors (RED, GREEN, BLUE, or WHITE).
6) Repeat for the other white colors (WHITE 1~11).
When selecting RGB TO W, you will only be able to define the values of RED,
GREEN and BLUE.
The values of RED, GREEN and BLUE configured from CALIBRATION > RGB TO
W will define the color temperature shown when the RGB faders are set to "255"
if COLOR > RGB TO W is active.
These notes intent to clarify the way the TOUR DMX personality works.
· Channel 1 controls the intensity of the currently projected color.
· When the slider is at the highest position (255) the intensity of the output is at its
maximum
· Channels 2, 3, 4 and 5 control the intensity ratio of each of the Red, Green, Blue,
and White LEDs
· When the slider is at the highest position (255) the intensity of each color is at its
maximum if SETTINGS > COLOR is OFF.
· You can combine channels 2, 3, 4 and 5 to create over 422 million colors
· Channel 6 selects the required Color Macro
· Channel 6 has priority over channels 2, 3, 4 and 5
· Channel 1 controls the intensity of the Color Macro
· Channel 7 controls the strobe of channels 2~6
· Channel 11 selects the target ID address
· Each independent DMX address may have up to 66 independent ID addresses
· An ID address of 0 will activate all ID address locations
· Channel 8 selects the preset Auto programs AUTO 01~10 or the custom Auto
programs CUSTOM 01~10
· When activating the custom Auto programs CUSTOM 01~10, it is possible to control
the Step Time and Fade Time using channels 2 and 3 respectively
· Channel 9 has priority over channels 2, 3, 4, 5, 6, 7 and 8.
· Channel 10 is for selecting the dimmer mode and speed. When DIMMER is set to
OFF, Red, Green, Blue, White and Dimmer are linear. Otherwise, DIM1 is the
fastest dimmer curve, while DIM4 is the slowest.
· Channel 12 defines which blocks are active.
-13-
Operation
COLORado™ 3p Tour User Manual Rev. 02c