Table of Contents
Advertisement
9. Replace the blown fuse with one of the proper
amperage.
Specified fuses:
0Main fuse:
AFuel injection system fuse:
B"HEAD" (Headlight) fuse:
C"SIG" (Signal) fuse:
D"DC TERM" (Auxiliary DC jack) fuse:
E"IGN" (Ignition) fuse:
F"BACK UP" (Backup) fuse:
G"FAN" (Radiator fan) fuse:
H"ECS" (Electronically controlled rear
shock absorber) fuse:
I Spare fuses (20 A, 10 A, 4 A, 3 A)
10. Connect the negative battery lead.
11. Install the air filter case by reversing the removal
steps.
12. Install the headlight unit, making sure to insert the
tabs on the headlight unit stay into the slots on the
bottom of the headlight unit.
13. Install the headlight unit bolts, and then tighten them
to the specified torque.
Headlight unit bolt tightening torque:
3 Nm (0.3 m·kgf, 2.2 ft·lb)
14. Install the top cover, the left and right side covers,
and the shroud.
NOTE:
@
If the fuse immediately blows again, ask a Yamaha
dealer to inspect the snowmobile.
@
8-34
40 A
10 A
20 A
10 A
3 A
20 A
3 A
4 A
10 A (not applicable)
Advertisement
Table of Contents
