Air Filter - Yamaha RX10RTL Owner's Manual

ESU04601

Air filter

Always check that there is no snow under the air filter
element frame.
1. Remove the shroud. (See pages 8-5–8-7 for removal
procedures.)
2. Unhook the air filter case cover fasteners.
3. Remove the headlight unit bolts and the two top
cover bolts near the headlight unit.
4. Slightly lift up the headlight unit, and then remove the
air filter case cover.
5. Lift up the air filter element frame and check the air
filter element. If there is any snow on the air filter ele-
ment, remove the element and brush off the snow,
and then install the air filter element.
6. Place the air filter element frame in its original posi-
tion, and then install the air filter case cover. Hook the
fasteners onto the air filter case cover.
7. Install the headlight unit, making sure to insert the
tabs on the headlight unit stay into the slots on the
bottom of the headlight unit.
8. Install the headlight unit bolts, and then tighten them
to the specified torque.
Headlight unit bolt tightening torque:
3 Nm (0.3 m·kgf, 2.2 ft·lb)
9. Install the top cover bolts.
10. Install the shroud.
NOTE:
@
After riding the snowmobile, make sure that there is no
snow under the air filter element frame.
@
6-10