Adjusting The Throttle Cable - Yamaha RX10RTL Owner's Manual

ESU04530

Adjusting the throttle cable

1. Remove the shroud. (See pages 8-5–8-7 for removal
procedures.)
2. Remove the headlight unit bolts and the two top
cover bolts near the headlight unit.
3. Disconnect the speedometer coupler and headlight
couplers, and then remove the headlight unit.
4. Loosen the locknut.
5. Turn the adjuster in or out until the proper throttle
lever free play is achieved.
Throttle lever free play a:
2.0–1.0 mm (0.08–0.12 in)
1 Headlight unit bolt
2 Locknut
3 Adjuster
6. Tighten the locknut.
7. Connect the speedometer coupler and headlight cou-
plers, and then install the headlight unit, making sure
to insert the tabs on the headlight unit stay into the
slots on the bottom of the headlight unit.
8. Install the headlight unit bolts, and then tighten them
to the specified torque.
Headlight unit bolt tightening torque:
3 Nm (0.3 m·kgf, 2.2 ft·lb)
9. Install the top cover bolts.
10. Install the shroud.
8-10