Table of Contents
Advertisement
7. If the position is incorrect, adjust the V-belt position
by removing or adding a spacer 4 on each adjusting
bolt 5.
CD-06E
V-belt position
More than 1.5 mm (0.06 in)
above the edge
From 1.5 mm (0.06 in)
above the edge to 0.5 mm
(0.02 in) below the edge
More than 0.5 mm (0.02 in)
below the edge
8. Tighten the adjusting bolts.
Adjusting bolt tightening torque:
10 Nm (1.0 m·kgf, 7.2 ft·lb)
9. Install the V-belt over the primary sheave assembly.
10. Rotate the secondary sliding sheave clockwise 6
and push 7 it so that it separates from the secondary
fixed sheave.
11. Install the V-belt 8 between the secondary sliding
and fixed sheaves.
12. Install the drive guard.
13. Install the left side cover and the shroud.
WARNING
@
Never run the engine with the V-belt or drive guard
removed.
@
8-18
Adjustment
Remove spacer
Not necessary
(It is correct.)
Add spacer
Advertisement
Table of Contents
