Table of Contents
Advertisement
1. Remove the shroud and the left side cover. (See
pages 8-5–8-7 for removal procedures.)
2. Remove the drive guard.
3. Rotate the secondary sliding sheave clockwise 1
and push 2 it so that it separates from the secondary
fixed sheave.
4. Pull 3 the V-belt up over the secondary fixed sheave.
5. Remove the V-belt from the secondary sheave
assembly and primary sheave assembly.
6. Temporarily install the new V-belt on the secondary
sheave assembly only, and then measure the V-belt
position. Do not force the V-belt between the
sheaves; the secondary sliding and fixed sheaves
must touch each other.
Standard V-belt position a:
From 1.5 mm (0.06 in) above the edge of the second-
ary sheave assembly to 0.5 mm (0.02 in) below the
edge.
8-17
Advertisement
Table of Contents
