High Beam Indicator Light; Low Coolant Temperature Indicator Light; Fuel Meter And Grip/Thumb Warmer Level Indicator - Yamaha FX Nytro FX10X Owner's Manual

Control functions
and then push the "SELECT" button for at
least 10 seconds while the snowmobile is
stopped.
Use the engine speed meter only when
G
checking the snowmobile and performing
basic maintenance. The engine speed
meter should not be used while riding the
snowmobile since the reading will vary from
the actual engine speed.
ESU10410

High beam indicator light "

The high beam indicator light comes on when
the high beams of the headlights are switched
on. (See page 15 for headlight beam switch
operation.)
1. High beam indicator light "
ESU10471
Low coolant temperature indi-
cator light "
The low coolant temperature indicator light
comes on when the coolant temperature is
low and informs the rider that the snowmobile
should be warmed up. After the engine is
started, warm it up until the indicator light
goes off.
12

1. Low coolant temperature indicator light

"
The snowmobile can be operated normally af-
ter the indicator light goes off.
NOTE:
Operate the snowmobile at low speeds when
the low coolant temperature indicator light is
on. If the engine speed is too high, maximum
engine speed is reduced to protect the en-
gine.
ESU10431
The fuel meter and grip/thumb warmer level
indicator have eight segments which show
"
the amount of fuel remaining in the fuel tank,
the grip warmer level, or the thumb warmer
level.
"
1. Fuel meter and grip/thumb warmer level in-
" "
Fuel meter and grip/thumb
warmer level indicator
dicator