High-Profile Pattern Drive Track; Lubrication - Yamaha FX Nytro FX10X Owner's Manual

Periodic maintenance
5. Adjust the drive track deflection to speci-
fication.
Drive track More than
deflection specified
Left adjusting
nut
Right adjust-
ing nut
ECS00591
CAUTION:
The right and left adjusting nuts should be
turned an equal amount.
6. Recheck alignment and deflection. If nec-
essary, repeat steps 3 to 5 until the prop-
er adjustment is achieved.
7. Tighten the rear axle nut.
Rear axle nut tightening torque:
75 Nm (7.5 m·kgf, 54 ft·lb)
Slide runners
Check the slide runners for wear and dam-
age.
If the slide runners reach the wear limit, they
should be replaced.
1. Slide runner
2. Wear limit height
Slide runner wear limit height:
10.5 mm (0.41 in)
64
Less than
specified
Turn in Turn out
Turn in Turn out
ECS00350
CAUTION:
Ride on fresh snow frequently. Operating
on ice or hard-packed snow will rapidly
wear the slide runners.
ESU12180

High-profile pattern drive track

FX10MT / FX10MTR / FX10MTRA
This snowmobile is originally equipped with a
51-mm (2.0-in) high-profile pattern drive track
specifically for use in deep snow riding condi-
tions.
Therefore, avoid prolonged operation on hard
surfaces such as ice, hard-packed snow, dirt,
etc., to extend the life of the track and slide
runners.
ECS00610
CAUTION:
Only use in deep snow riding condi-
G
tions.
Operation on areas with light snowfall,
G
ice, hard-packed snow, dirt, or grass will
result in rapid wear or damage to the
track and slide runners from lack of
snow which serves as a lubricant.
ESU12190

Lubrication

Lubricate the following points with the speci-
fied grease.