Operation; Starting The Engine; Break-In - Yamaha FX Nytro FX10X Owner's Manual

ESU11300

Starting the engine

EWS00200
WARNING
Be sure to check the "SAFETY INFOR-
G
MATION" section carefully before start-
ing the engine.
Make sure that the parking brake is ap-
G
plied.
NOTE:
Make sure that the engine stop switch is in the
on position. The starter motor cannot be oper-
ated when the engine stop switch is in the off
position.
Turn the main switch to the start position.
Warm up the engine until it does not run
roughly.
1. Start
ECS00330
CAUTION:
Release the switch immediately after the
G
engine starts.
If the engine fails to start, release the
G
switch, wait a few seconds, then try
again. Each attempt should be as short
as possible to preserve the battery. Do
not crank the engine more than 10 sec-
onds on any one attempt.
ESU11310

Break-in

There is never a more important period in the
life of your engine than the period between 0
and 500 km (300 mi). For this reason, you
should read the following material carefully.
Since the engine is brand new, do not put an
excessive load on it for the first 500 km (300
mi). The various parts in the engine wear and
polish themselves to the correct operating
clearances. During this period, prolonged full-
throttle operation or any condition that might
result in engine overheating must be avoided.
Operating your snowmobile for the
first time
Start the engine and let it idle for 15 minutes.
0–160 km (0–100 mi)
Avoid prolonged operation above 6000 r/min.
160–500 km (100–300 mi)
Avoid prolonged operation above 8000 r/min.

Operation

31