Yamaha FX Nytro FX10X Owner's Manual page 43

2. Press the throttle lever slowly to move the
snowmobile.
3. Turn the handlebar in the desired direc-
tion.
4. Squeeze the brake lever to stop the
snowmobile.
5. Apply the parking brake by moving the
parking brake lever to the left.
FX10 / FX10RTR / FX10RTRA /
FX10MTR / FX10MTRA
EWS00310
WARNING
Make sure that the throttle lever is fully
G
released and the snowmobile is at a full
stop before shifting.
Be sure to slide the shift lever to "FWD"
G
or "REV" until it stops completely and
only while the engine is idling.
Make sure that the area behind the
G
snowmobile is clear before reversing.
Watch behind.
Reduce speed and avoid sharp turning
G
when operating the snowmobile in re-
verse.
1. To select the desired operating position,
pull the shift lever out, slide it to "FWD" or
to "REV" until it stops, and then push it
back in.
1. Pull out.
2. Slide to "FWD" (forward).
3. Push in.
1. Pull out.
2. Slide to "REV" (reverse).
3. Push in.
ECS00070
CAUTION:
Do not shift from "FWD" to "REV" or from
"REV" to "FWD" while the snowmobile is
moving. Otherwise, the drive system
could be damaged.
NOTE:
The reverse buzzer beeps while the shift lever
is in reverse.
2. Release the parking brake by moving the
parking brake lever to the right.
3. Press the throttle lever slowly to move the
snowmobile.
4. Turn the handlebar in the desired direc-
tion.
5. Squeeze the brake lever to stop the
snowmobile.
Operation
37