Selecting Input Modes - Yamaha RX-V2400RDS Owner's Manual

PLAYBACK
Downmixing to 2 channels
You can enjoy 2-channel stereo playback even from multi-
channel sources.
Rotate PROGRAM (or press STEREO on the
remote control) to select 2ch Stereo.
PROGRAM
or
Front panel
2 c h S t e r e o
y
You can use a subwoofer with this program when SWFR or
BOTH is selected in LFE/BASS OUT.
Listening to unprocessed input signals
Press STRAIGHT/EFFECT to select STRAIGHT.
Two channel stereo sources are output from only the front
left and right speakers. Multi-channel sources are decoded
straight into the appropriate channels without any
additional effect processing.
STRAIGHT
EFFECT
Front panel
Press STRAIGHT/EFFECT again so that "STRAIGHT"
disappears from the display when you want to turn the
sound effect back on.
Virtual CINEMA DSP
Virtual CINEMA DSP allows you to enjoy the CINEMA
DSP programs without surround speakers. It creates
virtual speakers to reproduce the natural sound field.
If you do not connect surround speakers, Virtual CINEMA
DSP activates automatically whenever you select a
CINEMA DSP sound field program.
Note
Virtual CINEMA DSP will not activate, even when SURR L/R
SP is set to "NONE" (see page 51) in the following cases:
– When MULTI CH INPUT is selected as the input source.
– When headphones are connected.
34
10KEY DSP STEREO HALL CHURCH JAZZ
1 2 3 4
ROCK ENTERTAIN MUSIC TV THTR
5 6 7 8
EX/ES MOVIE THX /DTS NIGHT
9 10 +10 +100
CHP/INDEX
Remote control
STRAIGHT
or
EFFECT
Remote control

Selecting input modes

This unit comes with a variety of input jacks. Do the
following to select the type of input signals you want to
use.
1
Select the input source.
INPUT
or
Front panel
2
Press INPUT MODE to select an input mode.
In most cases, use AUTO.
INPUT MODE
or
Front panel
V–AUX DVR/VCR2 VCR 1 CBL/SAT
D V D A U T O
SP
A
AUTO
Automatically selects input signals in
the following order:
1) Digital signals*
2) Analog signals
DTS
Selects only digital signals encoded in
DTS. If no DTS signals are input, no
sound is output.
ANALOG
Selects only analog signals. If no
analog signals are input, no sound is
output.
* If this unit detects a Dolby Digital or DTS signal, the
decoder automatically switches to the appropriate sound
field program.
y
You can adjust the default input mode this unit selects when the
power is turned on (see page 56).
TUNER MD/TAPE CD-R CD
DTV CBL/SAT VCR 1 DVR/VCR2 DVD
Remote control
DTV CBL/SAT VCR 1 DVR/VCR2 DVD
INPUT MODE
TITLE
ENTER
SOURCE
Remote control
DTV DVD MD/TAPE CD–R CD TUNER PHONO
VOLUME
L L
Input mode
R