Tightening torque:
Coolant drain bolt:
10 Nm (1.0 m0kgf, 7.2 ft0lbf)
9. Connect the coolant reservoir hose.
10. Pour the recommended coolant into the
radiator until it is full.
11. Pour the recommended coolant into the
coolant reservoir to the maximum level
mark.
Recommended antifreeze:
High quality ethylene glycol antifreeze
containing corrosion inhibitors for alu-
minum engines.
Antifreeze and water mixing ratio:
1:1
Total amount:
1.61 L (1.42Imp qt, 1.70US qt)
Coolant reservoir capacity
(up to the maximum level mark):
0.25 L (0.22Imp qt, 0.26US qt)
cC
Hard water or salt water is harmful to the
engine. You may use soft water if you cannot
get distilled water.
12. Install the radiator cap and the coolant
reservoir cap.
13. Start the engine and let it idle for several
minutes. Stop the engine, and then check
the coolant level in the radiator. If it is low,
add more coolant until it reaches the top of
the radiator.
14. Check the coolant level in the reservoir. If it
is low, add coolant to the maximum level
mark.
15. Start the engine and then check for coolant
leakage.
NOTE:
If any leakage is found, have a Yamaha dealer
check the cooling system.
16. Install the panel.
8-16