Yamaha RAPTOR 700 Owner's Manual page 116

11. Install the crankcase engine oil filler cap,
and then tighten it to the specified torque.
Tightening torque:
Crankcase engine oil filler cap:
12 Nm (1.2 m0kgf, 8.7 ft0lbf)
12. Pour only 1.3 L (1.37 Imp qt, 1.16 US qt) of
the specified amount of recommended
engine oil through the engine oil tank filler
hole, insert the dipstick, and then tighten
the oil tank filler cap.
13. Start the engine, rev it several times, and
then turn it off.
14. Remove the engine oil tank filler cap, and
then gradually fill the oil tank with the
remaining oil quantity while regularly
checking the oil level on the dipstick.
Recommended engine oil:
See page 10-2.
Oil quantity:
Without oil filter element replacement:
1.75 L (1.85 US qt) (1.56 Imp.qt)
With oil filter element replacement:
1.85 L (1.96 US qt) (1.63 Imp.qt)
cC
8 In order to prevent clutch slippage (since
the engine oil also lubricates the clutch),
do not mix any chemical additives. Do not
use oils with a diesel specification of "CD"
or oils of a higher quality than specified. In
addition, do not use oils labeled "ENERGY
CONSERVING II" or higher.
8 Make sure that no foreign material enters
the crankcase.
15. Start the engine, and then let it idle for sev-
eral minutes while checking it for oil leak-
age. If oil is leaking, immediately turn the
engine off and check for the cause.
16. Turn the engine off, and then check the oil
level and correct it if necessary.
8-12