Rs-232C; Ups Shutdown (Via Rs-232C) - Toshiba 4200FA User Manual

4.3.2

RS-232C

The RS-232C serial communication interface is available via a DB9 female
connector located on the rear of the UPS (see Section 9 for DB9 connector
location). This interface allows control of the UPS from a personal computer
running special Toshiba software. The computer and the UPS are connected
through a serial RS-232C communication port. The available data from the UPS,
via the RS-232C communication link is shown below.
Operating Conditions
UPS Operating Status
(Described as Yes or No)
Fault Details
(Described as Occurred or Not Occurred)
The connector pin assignment and female connector outline are illustrated below.
Pin I/O Symbol
1 This pin is not used
2 Input RXD
3 Output TXD
4 Output DTR
5 - SG
6 Input DSR
7 Output RTS
8 Input CTS
9 This pin is not used
4.3.3

UPS Shutdown (via RS-232C)

When the UPS is operating from its internal batteries, a Shutdown order can be
sent to the UPS telling it to turn OFF after a user-specified amount of time. This
function can allow you to stop discharging the UPS batteries after an orderly
system shutdown has been completed. The UPS can be programmed to turn OFF
up to 8 minutes after the Shutdown command is given. This command can be
cancelled before the specified time has elapsed by following the directions listed
on the RS232 screen.
T O S H I B A
Input Voltage
Output Voltage
Output Current
Battery Voltage
Input Frequency
Output Frequency
Utility Power OK
Low Battery Voltage Detected
UPS in BYPASS Mode
UPS in NORMAL Mode
Input and Output Frequency Synchronized
UPD FAULT Occurred
DC Bus Over-Current
DC Bus Over-Voltage
DC Bus Under-Voltage
Input Over-Current
Overheat
Overload Being Timed
Overload (allowable time exceeded)
Output Over-Voltage (during Normal Mode)
Output Under-Voltage (during Normal Mode)
Description
Receive Data
Transmit Data
Data Terminal Ready
Signal Ground
Data Set Ready
Request To Send
Clear To Send
31
DB9 Female connector outline
(facing connector)
5 4 3 2
9 8 7
1
6