Communication Interface; Remote Contacts; Rs-232C; Option Card Slot - Toshiba UF1A1A015C6(T) User Manual

Communication Interface

Remote Contacts (IBM AS/400)
The remote contacts interface is a standard feature. It is provided
through solid state relays with contacts through a DB9 male
connector located on the back of the UPS (refer to the
Communication Option User Manual for a more detailed description
of this option).

RS-232C

RS-232C serial communication interface is a standard feature
provided through a DB9 female connector located on the backside of
the UPS (see "Electronics Module Layout ", page 9). This interface
allows control of the UPS from a personal computer (see the
Communication Option User Manual for a list of the data available
from the UPS via the RS-232C communication link)

Option Card Slot

The option card slot is a standard feature. An optional network
adapter card slides into the slot which is located on the back of the
electronics module (figure 1, page 9). This optional interface allows
the UPS to be monitored across the network or from any point on the
Internet (refer to the Communication Option User Manual for a more
detailed explanation of this option).

Troubleshooting

Warnings and Faults are those abnormal conditions that can occur
and could cause the unit to stop normal operation. These conditions
are detected by the protective circuitry in the unit. The UPS
"Warning/Fault" lamp will light red when a warning or fault occurs.
"Troubleshooting" involves monitoring the LED's on the front panel
and then interpreting the readout by using the warning and fault
mode display charts that follow.

Warning/Fault Modes

All warnings will cause the red "Warning/Fault" LED to flash. All
faults will cause the red "Warning/Fault" LED to light continuously.
Some warnings and most faults will cause the UPS to transfer to
bypass mode. In many cases, after the condition that caused the
fault is corrected the unit will automatically transfer back to normal
mode. For those cases where the unit does not transfer back
automatically use the "System Reset" procedure to transfer the UPS
back to normal mode (see "System Reset", page 16). If the system
faults again after being reset contact your Toshiba UPS service
representative at 1-800-231-1412.
TOSHIBA
22