Settings For Display Duration; Run Switch Select - Toshiba 4200FA User Manual

6.15.3 Settings for Display Duration

The LCD display is designed to switch off after a user-set period of inactivity. To
set the duration of inactivity allowed, press the MENU key to access the menu data
screens. Press the Down arrow key to scroll to the Display Duration screen. The
following system message is displayed:
Press the F1 key to adjust the LCD-Idle mode setting:
Press the Up/Down arrow keys to toggle from 3 MIN to 30 MIN. Press the ENTER
key to save the selection or press the MENU key to exit to the main menu and
discard the change.
Under any of the following conditions the LCD will remain on continuously without
regard to the Display Duration setting.

6.15.4 Run Switch Select

Press the MENU key to access the menu data screens. Press the Down arrow key
to scroll to the Run Switch Select screen.
Press the F1 key to display the following active adjustment screen:
Press the Up/Down arrow keys to toggle from RUN to SWITCH. Press the ENTER
key to save the selection or press the MENU key to exit to the main menu and
discard the change (Remote S/U option required). This function is available in the
Bypass mode only.
T O S H I B A
DISPLAY DURATION SET
<3 MIN> 30 MIN
>F1: DATA SET MODE
>∆/∇:PRV/NEXT SCREEN
DISPLAY DURATION SET
<3 MIN> 30 MIN
>∆/∇: CHANGE DATA
>ENTER:ACCEPT CHANGE
1) The UPS has received an emergency-off command.
2) The UPS is in battery discharge mode.
3) A fault has been detected in the main unit.
4) The UPS is in an overload condition.
RUN SWITCH SELECT
<LOCAL> REMOTE
>*F1: DATA SET MODE
>∆/∇: PRV/NEXT SCREEN
RUN SWITCH SELECT
<LOCAL> REMOTE
>∆/∇: CHANGE DATA
>ENTER:ACCEPT CHANGE
53