Device Config; Device Configuration; Parallel Port Mode - Toshiba Satellite 1400 User Manual

User's Manual
3. Click the OK button. If the character string you enter matches the registered
password, the password option is reset and the display changes to:
Not registered
If they do not match, the following message appears. You must repeat step 1.
Incorrect Password!!!
NOTE: If you enter the password incorrectly three times, the screen will
display:
Sorry, access denied!!! Powering off your
machine then powering it back on again are
required to regain access.
You will not be able to access the password option in HW Setup. In this
case you must turn the power off and back on to retry the procedure.
4. Follow the same procedures described in the earlier section, How to set the
password, to set a new user password.
Refer to the Supervisor password section later in this chapter for details on setting
the supervisor password.

Device Config

Device Configuration

This option lets you set the device configuration.
Setup by OS
All Devices
Parallel/Printer
This tab lets you set the Printer Port Type. Use the Windows Device Manager to
make settings for the Parallel port.

Parallel Port Mode

The options in this tab are ECP and Standard Bi-directional.
ECP
Standard
Bi-directional
7-4
Operating system sets devices that it can control. (Default)
BIOS sets all devices.
Sets the port type to Extended Capabilities Port (ECP). For
most printers, the port should be set to ECP. (Default)
This setting should be used with some other parallel
devices.