Log Placement - 4 Log Set - Empire Comfort Systems Studio DVP36DP31N-1 Owner's Manual

Studio series direct vent zero clearance gas fireplace heater
Table of Contents

Advertisement

Before you begin: This fireplace is supplied with a set of four
ceramic fiber logs. Do not handle these logs with your bare
hands. Always wear gloves to prevent skin irritation from
ceramic fibers. After handling logs, wash your hands gently with
soap and water to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of
this fireplace. Sooting and other problems may result if the logs
are not properly and firmly positioned in the fireplace. Please
refer to Figure 62, Figure 63, and Figure 64 and corresponding
WARNING, when completing the following log placement
steps.
1. Remove Decorative Doors (where applicable) by opening
and lifting straight up.
2. Remove Decorative Front. See page 64.
3. Release two glass frame spring clamps at bottom of
firebox
4. Place rear (#1) log onto two (2) pins on rear log support.
5. Place left, front (#2) log onto two (2) left, front pins on
burner pan.
6. Place right, front (#3) log onto two (2) right, front pins on
burner pan.
7. Place Branch (#4) onto one (1) pin on rear log
8. Place decorative rock in front of grates and sides of main
burner.
ATTENTION: Do not place decorative rock on logs or on
burner. The decorative rock should only be placed on the
fireplace floor.
9. After all logs are properly positioned, place small "dime"
size pieces of Rockwool lightly across the front round
"blueflame" ports. Place the ember material (Rockwool
pieces) side by side. Do not stack more than one layer of
embers across the burner ports. See Figure 62.
10. Replace glass door onto firebox.
11. Secure the two glass frame spring clamps at bottom of
firebox.
12. Replace Decorative Front. See Page 64.
13. Replace Decorative Doors (where applicable) by aligning
hinges over posts.
REAR LOG
LOCATOR TABS
FRONT LOG
LOCATOR PINS
26408-0-1009
LoG PLACEMEnT (4 LoG SET)
Figure 62
EMBER
PLACEMENT
Figure 63
WARNING: Failure to position the parts in accordance
with this diagram or failure to use only parts specifically
approved with this appliance may result in property damage
or personal injury.
Attention: Do not use Figure 63 or Figure 64 to order logs.
Refer to parts view on page 65 and parts list on pages 66 and
67 to order logs and/or ember material for your appropriate
fireplace model.
#4 - TOP BRANCH
#1 - REAR LOG
#2 - FRONT
Figure 64
#3 - FRONT
RIGHT LOG
LEFT LOG
Page 41

Advertisement

Table of Contents
loading

Table of Contents