Intermittent Pilot Lighting Instructions - Empire Comfort Systems Studio DVP36DP31N-1 Owner's Manual

Studio series direct vent zero clearance gas fireplace heater
Table of Contents

Advertisement

INTERMITTENT pILOT LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.
B. BEFORE LIGHTING smell all around the appli-
ance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch;
• do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
1. STOp! Read the safety information above.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot
by hand.
GAS CONTROL KNOB
SHOWN IN "OFF" POSITION.
5. Lower louver front assembly.
1. Set the thermostat to lowest setting. (if applicable.)
2. Turn off all electric power to the appliance if service is to
be performed.
3. Open bottom louver assembly.
26408-0-1009
causing property damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
OFF
ON
HONEYWELL
TO TURN OFF GAS TO AppLIANCE
• If you cannot reach your gas supplier, call
the fire department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don't try to repair
it; call a qualified service technician. Force or
attempted repair may result in a fire or explo-
sion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified ser-
vice technician to inspect the appliance and to
replace any part of the control system and any
gas control which has been under water.
6. Turn gas control knob clockwise
7. Wait ten (10) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas, SToP!
Follow "B" in the safety information above. If you don't
smell gas, go to the next step.
8. Turn gas control knob counterclockwise
"on".
9. Close louver front assembly.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the instructions
"To TURn oFF GAS To APPLIAnCE" and call your
service technician or gas supplier.
4. Turn gas control knob clockwise
force.
5. Close bottom louver assembly.
to "oFF."
to
to "OFF". Do not
Page 53

Advertisement

Table of Contents
loading

Table of Contents