Rear Blower Installation - Lopi Sheffield Owner's Manual

Optional Equipment
Rear Blower Installation (Part number 99000138)
The rear blower improves heat transfer by pushing heated air through the convection channel.
Operating instructions are described in the section "Blower Operation" on page 20.
1 The stove should be in place with the legs installed prior to installing the rear blower.
2 Follow the directions below to install the thermodisk.
Twist the wires together and feed them through the
channel, out the hole at the back left of the stove
(see the illustration below).
Wedge the snap disk in the the convection
chamber.
Snap Disk
Assembly
3 Install the wire clip following the directions below.
Travis Industries
a
b
NOTE:
Bend the legs on the
snap disk assembly to
insure a snug fit.
Use a screwdriver to
pry out the knock-out.
Slide the wire clip
over the edge of the
strip of metal between
the two knock-outs.
Wire Clip
Snap Disk
Wires
93508129
Feed the two snap disk wires into
the eye of the wire clip. Remove
all slack from the wire, making
sure not to dislodge the snap disk.
Pinch the eye of the wire clip to
secure the wires.
WARNING:
To prevent electrical shock, the
wires must be secured so they do
not contact the firebox above the
convection channel.
4 020204
33