Optional Equipment; Outside Air Boot Installation - Lopi Sheffield Owner's Manual

Optional Equipment

Outside Air Boot Installation

The outside air boot routes outside air to the stove for combustion. Refer to the section "Outside Air
Requirements" on page 11 for installation concerns. The directions below detail installation.
1 Install the cover plate following the directions below.
Install the 8" wide cover
plate included with the
outside air boot. It has a
clip to secure it to the
plate under the air control.
Replace the cover to
finalize installation.
2 Refer to the illustration on the following page to determine the location and size of the hole
penetrating the floor and. Cut the hole prior to locating the stove.
3 Attach gasket to the bottom edge of the lower air boot section (near the screen). Attach gasket
on top of the flanges on the upper air boot section. Slide the two sections together with both
seams facing the rear (do not attach the two sections at this time).
Travis Industries
Phillips
Screwdriver
93508129
(Part number 99200134)
31
4 020204