Rear Blower Installation (Part # 99000138) - Lopi 1250 Owner's Manual

Rear Blower Installation (Part # 99000138)

The rear blower improves heat transfer by pushing heated air through the convection channel. Operating
instructions are described in the section "Blower Operation".
a
Twist the wires together and feed
them through the convection chamber
and out of the slot on the rear of the
stove (either side).
Snap Disk
Assembly
Bend these legs on the snap
disk if it does not fit tightly
f
Attach the blower to the stove with the
three screws included with the blower.
3/8" Wrench
Plug the blower in. Do not route the power cord under or over the stove or in a
g
location where it may become damaged.
© Travis Industries
Optional Equipment
b
Wedge the snap disk directly
in front of the stiffener on the
left side.
d
Attach the wires from
the thermodisk to the
wires from the blower.
e
Position the blower near the rear of the stove. Tuck all excess wire into the
blower box, making sure it does not contact any moving parts. Make sure when
installing the blower, these wires do not become loose.
100-01277
c
Remove all slack from the wire and
secure with the included wire clip.
Snap Disk Wires
Wire Clip
WARNING:
To prevent electrical shock,
the wires must be secured
so they do not contact the
firebox above the
convection channel.
31
4111111