Outside Air Boot Installation
The outside air boot routes outside air to the stove for combustion. Refer to the section "Outside Air
Requirements" for installation concerns. The directions below detail installation.
1
Refer to the illustration below to determine the location and size of the hole penetrating the floor
and hearth. The knock-out (which is pre-removed) is 6-3/8" behind the face of the stove - it is 8"
wide and 4-1/4" deep. Cut the hole prior to locating the stove.
2
Attach gasket to the bottom edge of the lower air boot section (near the screen). Attach gasket
on top of the flanges on the upper air boot section. Slide the two sections together with both
seams facing the rear (do not attach the two sections at this time).
3
Follow the directions below for attaching the upper section of the air boot (with gasket) to the
stove.
4
Slide the lower section down until it contacts the hearth. Attach the two sections together
following the directions below
© Travis Industries
Optional Equipment
(Part number 99200134)
100-01161
37
4040608