Satellite Link - Toshiba D-VR18DTKB Owner's Manual

E9NG1BD_EN.book Page 46 Monday, April 7, 2008 5:54 PM

Satellite Link

You can set the unit to start recording whenever it
detects the video scart control from the external tuner.
Preparing for the Satellite Link Timer Recording:
[Preparation of the external tuner]
• The external tuner should be equipped with
some kind of timer function. Using timer function
of the tuner, set it to be turned on when it comes
to the time you want to start recording, and off
when it comes to the time you want to finish
recording. (Refer to the tuner's manual on how
to set the timer.)
• Make sure to turn off the external tuner when
you finish setting.
[Preparation of this unit]
• Make sure to select the desired Recording
mode beforehand.
Scart cable (not supplied)
HDMI OUT
1
Press [SAT.LINK].
2
Select the time, media or mode using
[U / D], then press [ENTER / OK].
Satellite Link
Start
0:00
To Standby Mode
3
Set the desired start time using
[U / D], then press [P].
• The hour can be selected among 0-23.
• Repeat this step to set the desired minutes.
4
Select the recording media using
[U / D], then press [P].
5
Select the recording mode using
[U / D].
Refer to "Recording Mode" on page 34 for DVD or
page 85 for VCR.
• If you want to edit the time, media or mode
press [L], then press [U
46
EN
External tuner
(not supplied)
DVD
DIGITAL COMPONENT
AUDIO OUT VIDEO OUT
Y DVD/VCR AV2(DECODER) ANTENNA
COAXIAL
IN
L
P P B B
AUDIO
/C /C B B
OUT
AV1(TV)
R
OUT
P
R
/C
R
DVD
Mode
VCR
DVD XP
/
D] to correct them.
6
Press [ENTER / OK].
"To Standby Mode" is highlighted.
Satellite Link
DVD
Start Mode
VCR
3:00 DVD
To Standby Mode
7
Press [ENTER / OK] again.
In a second, the unit will be turned off
automatically as it goes into the Satellite Link
standby mode.
• Until the time you set in "Start", the clock will
appear on the front panel display.
• "Sat" will appear on the front panel display at the
start time.
To cancel the Satellite Link function in the
Satellite Link standby mode:
Press [TIMER SET] to turn on the unit.
To cancel the Satellite Link function while the
Satellite Link Recording is in progress:
Press [S (STOP)] on the front panel of the unit.
Note
• If you have not set the clock, the clock setting
window will appear at the step 1. Follow to the step
4 in "Manual Clock Setting" on page 33.
• You cannot set the End time for the Satellite Link
Timer Recording on this unit.
• Recording picture will be distorted if the copy
protection signal is being detected during Satellite
Link Timer Recording.
• When a regular Timer Recording and the Satellite
Link Timer Recording are overlapped, the examples
are given below.
Example 1
Timer
Recording
Satellite Link
Actual
Recording
Example 2
Timer
Recording
Satellite Link
Actual
Recording
XP