One-Touch Timer Recording (Otr) - Toshiba D-VR18DTKB Owner's Manual

E9NG1BD_EN.book Page 40 Monday, April 7, 2008 5:54 PM
One-touch Timer Recording
(OTR)
Video VR
DVD-RW DVD-RW DVD-RW DVD-RW
D D VD+R DVD+R VD+R
This is a simple way to set the recording time in
blocks of 30 minutes. Check that the disc you are
recording onto has enough space left for the time you
set. (See page 86 for VCR recording.)
1
Follow steps 1 to 7 in "Basic
Recording" on page 39.
2
Press [REC ] repeatedly until the
I
desired recording time (30 minutes
to 8 hours) appears on the TV
screen.
One-touch Timer Recording will start.
Normal
Recording
8:00
• When the unit reaches the specified time, it will
be turned off automatically.
• To change the recording length during One-
touch Timer Recording, press [REC
repeatedly until the desired length appears.
• To cancel One-touch Timer Recording within the
specified time, press [STOP S].
Hint
• The remaining recording time will appear on the TV
screen during One-touch Timer Recording. Press
[DISPLAY] to see it on the TV screen.
• The remaining recording time will be displayed on
the front panel display during One-touch Timer
Recording.
• Unlike the timer recording, you can perform the
following operations during One-touch Timer
Recording.
- Turn off the power. (One-touch timer recording will
be cancelled.)
- Use [REC ] or [STOP S] on the remote control.
I
40
EN
DVD-R DVD-R DVD+RW D D VD+R VD+RW W
0:30
1:00
7:30
]
I
Note
• You cannot use the pause function during One-
touch Timer Recording.
• The unit will be turned off automatically under the
following conditions.
- No space remains on the disc.
- If a power failure occurs.
• If DVD One-touch Timer Recording is completed
during VCR playback or recording, the DVD will be
in stop mode and the VCR keeps the current mode.
• When One-touch Timer Recording is finished and
the power is turned off, the unit will switch to the
timer-standby mode automatically if a timer
recording has been programmed. Press
[TIMER SET] to cancel the timer-standby mode to
use the unit continuously.
• If the external equipment is connected to AV2, the
picture of the external equipment will be output
except during the DVD playback of this unit. Turn off
the external equipment or press [DISPLAY] to
output the picture of this unit.