Smeg Oven User Manual page 12

Manual cooking
The manual program "P40", that
can be edited by the user, does
not save the set cooking
parameters.
1. Save the program temporarily, as
described in paragraph " Editing /
saving a thermo-ventilated program".
Unlike saved programs, the cooking time
can be set to infinite,
2. After saving it, do NOT return to the
"OFF" status. Press
will perform a preheating cycle, showing
the text
3. When preheating is finished, a series of
beeps lasting 3 seconds will indicate that
it is possible to proceed with the cooking
operation. The text
the display.
4. To start cooking, hold button
down for 2 seconds. The display will
show the set cooking parameters in
sequence.
5. It is possible to start cooking early before
the preheating temperature is reached,
by holding
6. The operating parameters can be
modified during cooking as indicated in
paragraph Modifying a program during
cooking.
7. During the last minute of cooking, only
the countdown of the remaining 60
seconds will be displayed. At the end, a
beep and the text
36
.
, the appliance
on the display.
will flash on
down for 3 seconds.
flashing (for
Use
20 minutes) will indicate that cooking has
been completed.
8. At the end of cooking
on the display and the buzzer sounds
intermittently. To carry out the same
program press
will appear on the display.
Turn the knob to
maximum of 20 additional minutes.
9. To return to the "OFF" status hold
down for 4 seconds. The parameters set
for the program are deleted.
Preheating with delayed start
1. Turn the knob to
program "P39".
2. Press the knob for at least 3 seconds; the
display shows the current time flashing.
3. Turn the knob to
the cooking start time.
4. Press the knob; the display will show the
minutes flashing.
5. Turn the knob to
the minutes.
6. Press the knob; the display will show the
temperature flashing.
7. Turn the knob to
the temperature.
8. Press the knob; the display will show the
cooking start time flashing.
9. Turn the knob to
the preheating start time.
10. Press the knob; the display will show the
minutes flashing.
flashes
again. The text
/ to set up to a
/ to select
/ symbols to set
/ symbols to set
/ symbols to set
/ symbols to set