Fahrenheit To Celsius; Voltage Change Option (240V To 208V); Calibrating Oven Temperature; Beep Volume - Thermador CM301 Care And Use Manual

Do-It-Yourself Maintenance

Fahrenheit to Celsius

The oven has been preset to a Fahrenheit temperature.
To change to Celsius, follow these steps:
I. Turn off ovens.
2. Touch and hold the START pad and then the
CONVECTION pad at the same time for
3 seconds.
3. "F" appears in the temperature digits; release both
pads at the same time.
4. Touch CONVECTION; "C" replaces "F." This alternates
when CONVECTION is touched.
5. To complete the change, touch START.
Voltage Change Option
The oven has been preset for 240 VAC. If your residence
has been supplied with 208 VAC, the oven voltage can
be changed during installation.
1. Turn both ovens off. Touch OVEN OFF for each oven.
2. Touch and hold the START pad and the SELF CLEAN
pad at the same time for 3 seconds.
3. "240" appears in the display. Release both pads at
the same time.
4. Touch the SELF CLEAN pad. "240" is replaced with
"208." This alternates when SELF CLEAN is touched.
5. To complete the change, touch START.

How to Obtain Service

For authorized service or parts information, phone (800) 735-4328.
We want you to remain a satisfied customer. If a problem occurs that cannot be resolved
to your satisfaction write to Thermador Customer Support Center,
5551 McFadden Avenue, Huntington Beach CA, 92649 or call: 1-800-735-4328.
Please include the Model Number, Serial Number, Fabrication Date and Date of Original
Purchase and Installation.
Do-It-Yourself Maintenance
54
Built-in CM Oven Care and Use Manual

Calibrating Oven Temperature

The electronic thermostat has been preset to 0°F and
accurately maintains its setting. If the browning results
are too light or too dark for your preferences, you can
raise or lower the setting.
To change calibration of oven temperature for
single or upper ovens:
1. Turn off oven(s).
2. For single oven or upper oven, touch and hold the
START pad and then touch the BAKE pad.
3. "0" (zero) appears in the temperature digits; release
all pads at the same time.
4. Touch BAKE and 0 changes in increments of 5 degrees
each time it is touched. The maximum adjustment is
± 35ºF.
5. To complete the change, touch START.
To change calibration of oven temperature for lower
oven on double ovens:
1. Touch the ROAST pad.
2. Continue with Steps 3 through 5, as described above.
NOTE: The available temperature range for this
oven is 100ºF to 550ºF. This applies to all
conventional cooking modes. A change in
the calibration does not affect Dehydrate,
Proof or Warm modes.

Beep Volume

The volume of the beeps can be adjusted. Touch and
hold the START pad followed by the PROBE pad for three
seconds. Touch PROBE pad again to increase or decrease
volume, from levels 1 to 3. Touch START to set volume
selection.