Interpreting The Control Panel; Beep Volume; Touch 'N' Tilt Panel; F Number Codes - Thermador CM301 Care And Use Manual

Oven Features
Follow the control panel prompts to complete most oven functions. Familiarize yourself with the
indicators below before beginning.
Flashing Symbols or Numbers
Signals an incomplete setting; complete the step or touch
START.
1 Beep
Signals the receipt of an entry.
2 Beeps
Signal an error in entry.
4 Beeps
Signal the end of a setting.

Beep Volume

The volume of the beeps can be adjusted. Touch and hold
the START pad followed by the PROBE pad for three
seconds. Touch PROBE pad again to increase or decrease
volume, from levels 1 to 3. Touch START to set volume
selection.
Active Oven # Symbol
Indicates which oven was last set.
Probe Symbol
Displays the internal temperature of the meat rather than
the oven roasting temperature. Oven temperature can
be seen briefly by touching the cooking mode after touch-
ing START.
Single oven model control panel
shown in 20º open position.

TOUCH 'n' TILT PANEL

This panel is on single CM oven models only. It can be
used in the tilted or flush-to-oven position. Push in along
the center bottom of the panel to release latch and raise
panel upward. Push again to release latch and lower the
panel.
The Control Panel: Sights & Sounds
Built-in CM Oven Care and Use Manual
Door Lock Indicator
Displays during the Microwave, Defrost, Cooksmart™
Combination and Self Clean programs whenever the door
is locked. Door can be opened when symbol no longer
appears.
Pause
Displays when a Microwave, Defrost, Cooksmart™, or
Combination program is paused or interrupted and door
unlocks.
Err
Displays if an invalid temperature or time is entered.
Power Failure
After the power returns to the oven, the clock displays
the time when the power was lost or turned off.

F Number Codes

Display when there is a problem with the signal sent to
the electronic control board. See Solving Operational Prob-
lems, Page 56.
Convection Fan
Operates during any convection mode. The fan turns off
if the door is opened. The convection fan will also run
during the preheat time.
Component Cooling Fan
Activates during any cooking or self cleaning mode to
cool inner components and outer door surfaces. This air
is exhausted through the vent located below the lower
oven in double oven models. It continues to run until
components have cooled sufficiently.

208 VOLT CONNECTION

• Preheat time will be slightly longer.
• Broil time will be slightly longer.
• The Self Clean mode may need a longer clean time
than normal, depending on the amount of soil.
8
TM ,