Display Messages - Panasonic KX-MB1530E Operating Instructions Manual

10. Help

10.2 Display messages

To indicate the unit's status, one or more of the following messages will appear on the display.
Display
"CALL SERVICE"
"CHANGE CARTRIDGE"
"CHECK CARTRIDGE"
"CHECK DOCUMENT"
"CHECK PAPER #1"
"CHECK PAPER TRAY #1"
"CHECK PICK UP INPUT
TRAY #2"
"COOL DOWN FUSER"
"DRUM LIFE LOW REPLACE
SOON"
"DRUM LIFE OVER CHANGE
CARTRIDGE"
"FAX IN MEMORY"
"FRONT COVER OPEN"
68
Cause & Solution
R There is something wrong with the unit. Contact our service personnel.
R The toner cartridge is not inserted properly. Re-insert it correctly (page 10).
R There is something wrong with the toner cartridge. Replace the toner
cartridge.
R The toner cartridge is not inserted properly. Re-insert it correctly (page 10).
R The document was not fed into the unit properly. Remove the document,
and then press MStopN to clear the message. Re-insert the document. If
misfeeding occurs frequently, clean the document feeder rollers
(page 83) and try again.
R The ADF top cover is not fully closed. Push firmly on the front and rear edges
of the ADF top cover, and then feed the document again.
R Recording paper is not installed or the paper input tray has run out of paper.
Install paper (page 13).
R Recording paper was not fed into the unit properly. Re-insert the recording
paper (page 79).
R The paper input tray is not installed or is not inserted completely. Insert the
paper input tray into the unit.
R The loaded recording paper is not the appropriate size. Load recording
paper of the size that is shown on the display.
R If this message is often displayed, also change the recording paper size
setting (feature #380 on page 54).
R The recording paper size setting (feature #380 on page 54) is set to
"16K", so received faxes will have been stored into memory. Change the
recording paper size setting and load the appropriate recording paper.
Note:
R "#1": Check the paper input tray. The displayed paper size depends on the
recording paper size setting (feature #380 on page 54).
R "#2": Check the manual input tray. The displayed paper size depends on
the recording paper size setting (feature #381 on page 54).
R Recording paper was not fed into the unit properly. Load the paper again
(page 79).
R The unit is cooling down the fuser unit. Wait for a while.
R The drum inside the toner cartridge is reaching the end of its life. If you
don't have a new cartridge handy you should buy one as soon as possible
as your current cartridge is near the end of its useful life.
R The drum inside the toner cartridge has reached the end of its useful life.
Replace the toner cartridge immediately.
Note:
R As a temporary measure, you can press MStartN to continue printing.
However, the printing quality may be poor, so we do not recommend
continuous use of a cartridge once it has exceeded its useful life.
R The unit has a document in memory. See the other displayed message
instructions to print out the document. For fax memory capacity, see
page 85.
R If the PC fax setting (feature #442 on page 60) is set to "ALWAYS",
– check the connection between the computer and the unit.
– check that the computer is turned ON.
R The front cover is open. Close it.