Panasonic KX-MB1530E Operating Instructions Manual page 59

Feature/Code
Confirming the destination
before sending a fax
MBNM4NM2NM0N
Setting dial keypad entry
restriction
MBNM4NM2NM1N
Setting the fax number
re-entry before sending
MBNM4NM2NM2N
Setting auto reduction
feature
MBNM4NM3NM2N
Changing the fax activation
code
MBNM4NM3NM4N
Setting the auto
disconnection
MBNM4NM3NM5N
Changing the silent fax
recognition ring count
MBNM4NM3NM6N
Selection
M0N "OFF" (default): Deactivates this feature.
M1N "ON": You can send a fax after confirming the destination. When the
displayed destination is correct, press MStartN to send the fax.
M0N "OFF" (default): Deactivates this feature.
M1N "ON": If you do not wish to dial a fax number manually using the dial keypad,
activate this feature.
Note:
R If you select "ON", you cannot make redial calls to fax numbers entered
using the dial keypad.
R If you select "ON", the fax number re-entry setting (feature #422 on
page 59) will be deactivated.
M0N "OFF" (default): Deactivates this feature.
M1N "ON": If you dial a fax number manually using the dial keypad, you have to
re-enter the number and press MStartN. When the 2nd entry number matches
the 1st entry number, you can send the fax.
To receive a fax document that is longer than your recording paper.
M0N "OFF": Deactivates this feature.
M1N "ON" (default): The unit will fit received documents onto your recording
paper.
If you wish to use an extension telephone to receive faxes, activate this feature
and program the activation code.
Important:
R The fax activation code must be different from the code that you
programmed on the answering machine.
M0N "OFF"
M1N "ON" (default)
1. MMenuN A MBNM4NM3NM4N
2. Press M1N to select "ON". A MSetN
3. Enter your code from 2 to 4 digits, using 0-9, MGN and MBN.
R The default code is "H#9".
4. MSetN A MMenuN
To answer a call with an extension telephone in TEL/FAX mode (page 44),
activate this feature and program the code.
M0N "OFF"
M1N "ON" (default)
1. MMenuN A MBNM4NM3NM5N
2. Press M1N to select "ON". A MSetN
3. Enter your code from 2 to 4 digits, using 0-9 and MGN.
R The default code is "H0".
4. MSetN A MMenuN
To change the number of times the unit rings while in TEL/FAX mode.
M3N "3" (default)
M4N "4"
M5N "5"
M6N "6"
M7N "7"
M8N "8"
M9N "9"
Note:
R See page 44 for details.
8. Programmable Features
59