Setting Date And Time - Panasonic VDR-M55EB Operating Instructions Manual

Setting Date and Time

Set the current date and time so that the date and time you make a recording can be recorded correctly.
The following procedure can also be used to correct the date and time you have already set.
1
Turn the DVD Video Camera on.
2
Press the MENU button.
The menu screen will
appear.
3
Press the f / e button
to choose "Date Setup"
and then press the c
button to choose "Date
Set".
4
Press the c button.
The figure for the day will
be selected.
[The digit that is
highlighted first depends
on the date display format
(set up in Date Mode): The digit on the left end of
the date display will be first highlighted.]
:
Note
After highlighting the day, press
change the day. If you press the
changing the day, the screen for verifying the set date
will appear instead of screen for setting month, year or
time.
38
5
Came r a F u nc t i on s Se t u p
P r o g r am AE : A u t o
Wh i t e Ba l . : A u t o
S I S : On
D i g . Zo om : 4 0 x
W i n d C u t : O f f
ENTER RETURN RAM
6
Da t e Se t u p
1. 1. 2005
Da t e Set
Da t e Mode 12 : 00
ENTER RETURN RAM
7
Da t e Se t u p
1. 1. 2005
Da t e Se t
Da t e Mode 12 : 00
ENTER RETURN RAM
Important Note
•
f e
/ button to
A
button after
•
f
Press
to select, and then press
activate.
Press the f / e button to change the day.
Press the d / c button to move the highlight
to the month, then repeat step5 to set the current
date and time.
:
Note
To stop date/time setting midway, press the
After setting the current
date and time, press the
A button.
The screen for verifying
the set date will appear.
If the displayed date and time are correct, use the
control buttons to choose "YES", and then press
the A button.
The date and time will be set, and the DVD Video
Camera will enter the recording pause status.
Choosing "NO" will restore the menu screen.
:
This DVD Video Camera incorporates a rechargeable
battery to store the date and time in memory. If this built-
in battery is exhausted, the date and time will be reset. To
prevent this, connect the AC adaptor/charger to DVD
Video Camera every 3 months, and leave them for at
least 24 hours with the DVD Video Camera turned off:
The built-in battery will be charged.
The built-in battery cannot be compensated.
WARNING
THE LITHIUM BATTERY IN THIS
EQUIPMENT MUST ONLY BE REPLACED
BY QUALIFIED PERSONNEL. WHEN
NECESSARY, CONTACT YOUR LOCAL
PANASONIC SUPPLIER.
e d c
/ / / buttons
A
to
C
button.
Da t e Se t
21. 3. 2005 8 : 0 0
Da t e s e t u p?
YES NO
ENTER RAM