Table of Contents
Advertisement
Message
DISC ACCESS
DISC ALMOST FULL
Disc error has occurred.
Finalising is not
complete.
Disc error has occurred.
Format the disc now?
Disc error has occurred.
Formatting is not
complete.
Disc error has occurred.
Keep disc inside &
restart.
Disc error.
144
Cause & Troubleshooting
The recorded scene is being stored on disc.
Wait until the message disappears, and you can start to use the
DVD Video Camera.
This DVD Video Camera is verifying whether the correct disc has
been inserted.
Wait until the message disappears, and you can start to use the
DVD Video Camera.
The disc will soon be full, and recording will be impossible.
Delete unnecessary scenes and try the disc again, or use another
disc.
• Disc error occurred during finalising, and finalising failed.
Replace the disc.
• See *3 on 148.
• Has the disc been initialised on PC? Has initialising the disc on
PC been interrupted?
Choose "YES" and initialise the disc when using it on this DVD
Video Camera. initialising the disc will erase all data on it.
• See *2 on page 148.
The disc may be dirty.
Remove the disc and wipe off fingerprints, dust, etc. before reusing
it, or use another disc.
This message may also appear if you insert a disc for which
formatting was interrupted midway. In this case, use another disc.
Disc error could have occurred during editing of scenes.
Turn off the DVD Video Camera with the disc being used in it,
connect AC adaptor/charger, and then power the DVD Video
Camera again. Repair of scenes will be tried.
• Use another disc.
• See *3 on page 148.
• Mismatch in recording information may be caused by editing
done on some device other than this DVD Video Camera.
initialise the disc or use another disc.
• initialising the disc will erase all data on it.
Reference
page
49, 50
30, 31, 95
120
118
28, 118
43
26, 28
118
Advertisement
Table of Contents
