Removing Disc
1
Press down the DISC EJECT
lever once and release it.
In a moment, the
cover of disc
insertion
compartment
will open
slightly.
2
Open the cover by
hand and remove the
disc.
While pressing down
on the spindle, grasp the
edge of the disc and
gently lift it out.
:
Note
•
Do not use excessive force
when opening the cover.
•
Do not touch the pickup
lens or the recording/
playback side of the disc.
•
If the disc cover is open, the power will not turn off even
if the power switch is set to "OFF".
•
When you open the lid, the ACCESS/PC indicator
flashes red. Do not leave the lid open.
3
Gently push the section
labelled "PUSH CLOSE"
on the cover of disc
insertion block, to close
the cover.
46
Pickup lens
:
Note
•
It is recommended that you turn the DVD Video Camera off
before inserting or removing disc to prevent misoperation.
•
If the disc cover is open, the power will not turn off even
if the power switch is set to "OFF".
•
Do not remove the battery or disconnect the AC adaptor/
charger during removal of the disc or until power is
completely turned off: If you do, the disc cover will not
open. If this happens, reattach the battery or AC adaptor/
charger, push down the DISC EJECT lever once, and
then release it.
•
Do not insert anything other than the 8 cm DVD-RAM or
DVD-R disc into the disc insertion block: Doing so could
cause malfunctions.
•
Set the power switch to "OFF" to turn the DVD Video
Camera off.
•
When inserting or removing the disc, be careful not to
touch the inside of DVD Video Camera [especially, the
lens of laser pickup (see "Terminology" on page 160)].
•
When inserting or removing the disc, connect a charged
battery or AC adaptor/charger to the DVD Video Camera:
The disc cover will not open unless the DVD Video
Camera is powered.