Table of Contents
Advertisement
5.3 Utilities
Save the user configuration to the flash memory or configure the rebooting or updating
method.
Save Configuration
The is the menu to save configuration to the flash memory.
Reboot
This is the menu to reboot the system.
Factory Default
This is the menu to set the system to the factory default.
System Update
This is the menu to update the system.
5.3.1 Save Configuration
It saves the configuration to Netcam's flash memory so the user configuration stays after
rebooting or the power is off.
Video Netcam | SNC-L200
Smart Viewer Administration Menu
42
5.3.2 Reboot
This is used when the user wants to reboot the system.
During rebooting, you cannot connect to Netcam. Please close Internet Explore window,
wait for 1 minute, and then connect to it again.
5.3.3 Factory Default
This is used to reset all the setup values to factory default conditions.
5.3.4 System Update
This is the Utility Menu to upgrade the system when an upgraded system software is
released.
There are two types of update: Normal Update and All Update.
In general, there is usually no "All Update." Instead, "Normal Update" is generally used.
* The latest software version of SNC-L200 can be downloaded from Samsung's website
http://www.sec.co.kr.
Video Netcam | SNC-L200
Smart Viewer Administration Menu
43
Advertisement
Table of Contents
