Table of Contents
Advertisement
This is where to configure whether using this Service or not.
Service
Selecting "Enable" will allow you to use "Alarm Notification" function.
It means Simple Mail Transfer Protocol (SMTF) Server address.
SMTP server
This address is used to transfer E-mails.
address
Enter the after @ part of the Email Address you use.
Authentication Login
It is recommended to select "Enable."
When using the Authentication Login, enter User ID and User
User ID / Password
Password of the sender's Email Address. They are usually
designated at the time the mail service is subscribed.
Enter the sender's Email Address.
Sender (E-mail)
Do not use a bogus name because the mail server often check it to
block Spam mails.
E-mail address 1~4
Up to 4 Email Addresses can be registered to receive video data.
Up to 5 images can be sent with a 0.5-second interval each. The
Image Count
number of image count will be shown.
Assuming the sender's Email Address is "inyoung.heo@samsung.com," and the Password
is "1234567," the "Alarm Notification" should be configured as follows.
Video Netcam | SNC-L200
Smart Viewer Administration Menu
36
5.2 Network Configuration
Perform general network configuration. If network configuration is not done properly, you
cannot to transfer images via Internet Explorer or configure Netcam on the web. Please
ask your network administrator and enter the following setup information correctly. To
apply the settings to Netcam, you must click "Apply" button.
Network Configuration
This is the menu to set "Static IP" or "DHCP."
PPPoE(ADSL)
This is the menu to set PPPoE (ADSL).
Network Ports
This is the menu to set "HTTP Port."
View Network Status
This is the menu to view current system network status.
Network Status
This is the menu used to notify the information of IP Address
Notification
that is dynamically allocated, such as DHCP or PPPoE.
DDNS Configuration
This is the menu used to set DDNS.
Video Netcam | SNC-L200
Smart Viewer Administration Menu
37
Advertisement
Table of Contents
