Protecting Against Unauthorised Access - Gigaset SL75 WLAN User Manual

Handset settings
Depending on the mode of setting for the
date and time, you must enter the wake-
up time in 12 or 24 hour mode (see Time:,
page 67).
A wake-up call is signalled on the handset
by the selected ringer tone (page 70). The
wake-up call sounds for about 60 seconds.
The display shows Alarm Clock
date and time.
During a call, the wake-up call is signalled
by a short tone.
The wake-up time is saved.
Deactivating the wake-up call
Requirement: A wake-up call is sounding.
Press the display key or any
§Silence§
key.
The alarm clock is still switched on.
Protecting against unauthorised
access
Protect the handset with a PIN known only
to yourself. If a PIN is entered it is
requested when the handset is switched
on. When the phone is supplied no PIN has
been entered.
Caution:
If you do not assign a PIN, every subscriber to
the WLAN has free access to your handset set-
tings.
Changing the Handset PIN
You can save a 4-digit Handset PIN.
Caution:
– Memorise the new Handset PIN well! If you
forget it, you can change it using the
Admin PIN via the Web configurator.
– For how to set/change or delete PINs using
the Web configurator, see page 80.
¢ ¢
v Ð
Change HS PIN
~
Enter current Handset PIN if
necessary und press
72
~
a
Notes:
– To delete the Handset PIN: leave the input
– You cannot correct wrong entries when you
plus the
Clearing handset blocking
If you enter a wrong PIN three times in a
row, the handset will be blocked. In the
display, a corresponding notification and
the handset's IP address are shown.
You can only clear the blocking via the
Web configurator.
¤
¤
¤
The handset blocking is cleared.
§OK§
a
Notes:
– If you wish to clear the handset blocking at
– If you wish to launch the Web configurator
.
§OK§
Enter new Handset PIN (four
digits 0–9) and press
Press and hold (idle status).
field for the new PIN empty and press §OK§.
are entering the PIN. If necessary, cancel
the input (a or ") and start the proc-
ess again.
Start the Web configurator with the IP
address displayed (page 75).
Change the Handset PIN
menu (page 80).
Close the Web configurator (page 79).
Press the display key to con-
firm the information on the
handset display. The handset
switches off.
Press the End call key to switch
the handset on again and reg-
ister with the new Handset
PIN.
a later time, press the
handset switches off. The message with
the handset's current IP address will be dis-
played again the next time you switch on.
in a different WLAN: press the
key. This launches the connection wizard
(page 59).
.
§OK§
via the Admin
display key. The
§OK§
display
§Scan§