Table of Contents
Advertisement
Care
¤
Wipe the handset with a damp cloth
(do not use solvent) or an antistatic
cloth.
Never use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1. Switch the handset off and remove
the battery immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will
normally be able to use it again.
Troubleshooting - FAQs
You can find more tips and answers as well as
the current firmware for your handset on the
Siemens pages on the Internet:
www.siemens.com/gigasetcustomercare
Handset no longer reacts or does not react
correctly
This may be caused by the changes made
to the handset settings.
The handset Web configurator contains
functions with which you can reset the
settings.
Appendix
!
¤
Establish a connection to the handset's
Web configurator using the PC
(page 75).
¤
Reset the user settings (page 102).
¤
If the handset still does not react, reset
the default settings on the handset
(page 102).
If the Web configurator is no longer acces-
sible:
¤
Remove and refit the handset's battery.
The SSID of your access point is not
displayed
When searching for access points in the
handset's receiving range (
of your access point is not displayed.
Broadcasting of the SSID may be blocked
at the access point (it is "hidden").
¤
Change the setting at the access point
temporarily.
Or
¤
Enter the SSID manually
option during profile creation)
fig.>
It is not possible to register in the WLAN
The access point is accessible (is displayed
during scanning) and you have created
and activated a profile for the access
point. Nevertheless, the handset displays
No Access
Point.
Possible reasons:
u
The access point is using access restric-
tion through entered MAC addresses in
which your handset is not entered.
u
The access point requires authentica-
tion with a certificate (802.1x with EAP
type TLS). The necessary certificates
are not saved on the handset.
u
You may have entered the WLAN secu-
rity settings incorrectly.
Care
), the SSID
§Scan§
(<Manual Con-
111
Advertisement
Table of Contents
