Setting The Time - Pioneer X-HX700 Operating Instruction

Setting the Time

The time (24-hour format) is
indicated on the CD/receiver's
display panel.
The first time the power is con-
nected, the display panel flashes to
indicate that the time needs to be
set. Use the CD/receiver's buttons to
do this as described below.
Display panel: shows the current time
CANCEL button
ENTER button
TIMER SETTING button
Before setting the time
Turn the system's power off before making the
time settings.
If the power is currently on, press the POWER
button to switch it off.
+ / – button
Example: To set the time to 7:15 AM
1
Press and hold the TIMER SETTING
button for at least three seconds.
The CD/receiver turns on and the back light
of the display panel lights.
Display panel
The "Hour" flashes.
2
Use the + and/or – buttons to set the
hour, then press the ENTER button.
Display panel
The "Minute" flashes.
3
Use the + and/or – buttons to set the
minute.
One way to ensure an accurate time setting
is to temporarily set a time that is slightly
faster than the actual time, then use the time
announcements on the radio or TV to set the
time. After doing this, go on to Step 4
below.
4
Press the ENTER button.
Display panel
The CD/receiver turns off, then the clock
starts to run.
How to cancel
Press the CANCEL button while setting the time (before
pressing ENTER at Step 4). This resets the time to its
status prior to Step 1.
Note on the time display
The time display does not appear when the system's
power is on.
You must reset the time setting in the
following situations:
• The power plug has been disconnected from the
wall outlet, such as when moving the system.
• A power outage has occurred.