Philips Fax Machine Manual page 27

You can use your fax machine to make copies of an original. When
copying your fax machine switches automatically to resolution FINE.
You may also choose PHOTO resolution when copying photographs
or for an even finer resolution.
Hold your documents face up. The documents must rest against
the document width adapters. To prevent several sheets being
drawn into the machine at once, please straighten the documents to
the same height before inserting them in the document feed (see
also The fax / Sending faxes). You can load up to ten pages at
once.
Choose the desired resolution by pressing FINE/PHOTO and
then press START/COPY.
The document will now be fed into the machine. It will appear at
the front of the machine again. The last page of the copy will not
appear completely in front of the document outlet. Pull it out
softly.
If your local copies or received faxes are blank, the document was
inserted the wrong way.
You can interrupt the process of copying by pressing STOP.
The three codes which you can enter with this function help you, when
you receive a call on the additional telephone or wish to transfer a call or
fax to your fax machine.
Code for starting your fax machine from another telephone: *5.
Serial connection: Code for transferring a call from another tel-
ephone connected serial to your fax machine: *0. Please note
that when using this code you have to replace the handset of your
additional device after you have entered the code. See chapter The
telephone / Call transfer.
Parallel connection: Code for switching off the fax machine of an
additional telephone connected in parallel: **. For fax ma-
chines with built-in answering machine: This code is also
used to switch off the outgoing message if the answering machine is
already activated.
To be able to use this function you must set your additional or cordless
telephone to tone dialling. If your telephone service is not compatible
with this dialling method and requires pulse dialling, you must temporar-
ily set your additional device to transmit tone dial signals. Please refer to
the operating instructions of your additional device to find out how to
make this temporary adjustment.
! Only change the specified codes if absolutely
necessary!
Select function 34 and press OK. Enter a two-digit code. The first
digit should be the sign * or #. Confirm with OK. Execute this
procedure for each of the three codes.
Please note that the three EASYLINK codes must be different. If
you enter the same code more than once, the following message
appears on the display:
%
CODE NOT OK